Hello everyone, nice to see you again. I’m your friend Full-Stack Jun, here to talk about Wireshark Win10.
I encountered this issue on the Win10 system because the built-in Winpcap in Wireshark doesn’t support Win10, resulting in a display issue as shown in the figure:
1. The solution to this problem is to download a Winpcap supported by Win10. The download link is provided, and the interface appears as shown:
Click on the red area to download. Note: After downloading Win10Pcap, make sure to close Wireshark before installing, otherwise an error may occur during installation.
2. After installation is complete, reopening Wireshark will not show the interfaces not found error.
“`